• 會員登入
2 Year Warranty

PCI-1245L-AE CIRCUIT BOARD, Basic 4-Axis SoftMotion Controller

  • Encoder input is 10 MHz for 4xAB mode, 2.5 MHz for CW/CCW mode
  • Pulse output up to 1 Mpps and the output type can be switched to differential or single-end by jumper setting
  • Supports 2 axis linear interpolation
  • Supports T/S-curve
  • Supports speed override
  • Hardware emergency input
  • Watchdog timer
  • Supports programmable acceleration/deceleration rate
  • Programmable interrupt
  • 預約(案場規劃)或(軟硬整合)諮詢服務
Certifications CE FCC RoHS

已含稅
加入購物車 直接結帳

週邊配件

PCI-1245L-AE

主產品:PCI-1245L-AE

CIRCUIT BOARD, Basic 4-Axis SoftMotion Controller

週邊配件

  • CIRCUIT BOARD, PCI-1240 Wiring Terminal, DIN-rail Mount

    NT$2,510
  • CIRCUIT MODULE, 2-Axis 50-pin SCSI DIN-rail motion wiring board

    NT$2,615
  • 50-pin SCSI M-M Shielded Cable, 1m

    NT$881
  • 50-pin SCSI M-M Shielded Cable, 3m

    NT$1,565
  • CABLE, SCSI-100 to 2*SCSI-50 Shielded Cable, 1m

    NT$2,090
  • CABLE, SCSI-100 to 2*SCSI-50 Shielded Cable, 2m

    NT$2,615
  • CABLE, 100Pin to two 50Pin SCSICable for PCI-1240,3M

    NT$3,035
  • SCSI-100 Wiring Terminal, Connect

    NT$3,455
  • CABLE, SCSI-100 Shielded Cable, 3m

    NT$4,085

{{relatedTitle}}

主產品 + {{numOfSelectedRelatedProducts}}週邊配件

小計 {{subTotalStr}}

詳細規格

General

  • Humidity (Storage) 5~95% RH (non-condensing)
  • Humidity (Operating) 5~95% RH (non-condensing)
  • Connectors 1 x 100-pin SCSI female connector

Counter/Encoder Input

  • Counting Range 32-bit

Encoder Type and Interface

  • Input Type Quadrature (A/B phase) or up/down
  • Input Range 0~1 VDC for low; 3.5~5 VDC for high
  • Max. Input Frequency 4 MHz under x4 A/B phase mode
  • Counts per Enc. Cycle x1, x2, x4 (A/B phase only)

Pulse Type Motion Control

  • Motor Driver Support Pulse-type servo/stepping
  • Interpolation 2-axis linear interpolation
  • Max. Output Speed 1 Mbps
  • Step Count Range ±2, 147, 483, 646
  • Pulse Output Type Pulse/direction (1-pulse, 1-direction type) or CW/CCW (2-pulse type)
  • Velocity Profiles T-Curve, S-Curve

Frequency

  • Signal Input Logic level 1: 10~30 VDC Logic level 0: 0~3 VDC

Local I/O

  • General Input Signal Input voltage: 24Vdc Max. Input delay: 100us Max. (isolation delay) Signal: EMG (emergency stop) ORG, LMT+, LMT- INPOS (in position signal) LTC (counter latch) RDY (servo ready) ALARM (servo alarm)
  • General Output Signal Output voltage: Open collect 24Vdc Max Output delay: 100us Max. (isolation delay) Sink current: 100mA per channel Signal: CMP (position compare in range output) SVON (servo on) RALM (reset driver alarm) ERC (counter clear signal)
x
聯絡我們

0800-777-111

9:00-17:30

Contact Advantech